Essick 1999 Manual De Instrucciones página 2

Note: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not in-stalled and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Installing and Replacing the Batteries
The Remote Control uses two "AAA" size batteries
(1.5V DC). Follow these steps to install or replace
the batteries:
1. Open the battery cover, below the stand.
2. Insert the batteries as indicated by the polarity
symbols (+ and -) marked inside the battery
compartment.
3. Replace the battery cover
2