Functional Description; Removing/Inserting The Battery - Milwaukee 2509-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

1
7 6
8
15
14
1. Dust box latch
2. Depth gauge button
3. Nozzle release lever
4. Nozzle
5. Nozzle assembly
6. Side handle clamp attachment point
7. Dust box with filter
8. Side handle clamping collar assembly
9. Depth gauge
10. Tool and bit depth gauge button
11. Clamp lever
12. Side handle grip
13. Bit brush
14. Power switch
15. Fuel gauge
3
2
10 11
9
13
WARNING
the battery. For specific charging instructions,
4
read the operator's manual supplied with your
charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
pack any time the tool is not in use.
To insert the battery, slide the pack into the body
5
of the tool. Make sure it latches securely into place.
WARNING
mended for this tool. Others may be hazardous.
To reduce the risk of injury, always remove the
battery pack before removing the dust box. Do
not use tool without dust box and HEPA filter
in place.
Installing/Removing the Dust Box
To remove the dust box:
1. Turn OFF the tool.
12
2. Remove the battery pack.
3. Press the dust box latches. (1)
4. Pull the dust box away from the
HAMMERVAC™. (2)
5. Empty debris by holding away
from the user's face and tapping
dust box into a trash can, pail,
or other reasonable container.
For best cleaning results,
connect a vacuum
hose with dust extrac-
tion adapter (Cat . No.
49-90-1959) to the
dust box port and suc-
tion out debris.
6. If necessary, pull the
HEPA filter away from
the dust box and tap
clean. Do not clean
with water or compressed air. After about 1500
holes or loss of suction, discard and replace HEPA
filter (Cat. No. 49-90-2306).
To install the dust box:
1. Slide the dust box into the body of the
HAMMERVAC™.
2. The dust box latches should snap into place.
NOTE: Do not operate the HAMMERVAC™ without
the dust box and HEPA filter in place. Dust box cannot
be installed without HEPA filter.
CAUTION
HAMMERVAC™ is largely dependent on the filter.
A dirty filter will reduce the air flow and overall
efficiency of the system. Do not clean with water
or compressed air. Remove from dust box and
tap clean.
4
ASSEMBLY
Recharge only with the
charger specified for
Always lock the trigger
or remove the battery
Only use accessories
specifically recom-
and HEPA Filter
Dust box
port
HEPA
filter
Keep filter clean. Effi-
c i e n c y
1
2
o f t h e