Denver MDA-240 Manual Del Usuario página 5

6. Press the TIMER button again, the timer "VOL 15" indicator appears on the display and flashes, adjust
the timer volume high or low by pressing the SKIP/TUNE SEARCH (UP or DOWN) button.
LISTENING TO YOUR RADIO
Hints for better reception
This unit carries a single lead wire DAB/FM antenna, to obtain the best performance, you should fully
extend the wire antenna and adjust the position as well as the direction until you find the best reception.
For ideal DAB+ reception, always maintain the lead wire antenna in a vertical position (holding it upward or
downward behind the unit) is highly recommended.
DAB mode
When the unit is powered up for the first time, it will be in standby mode, and the display will show "Welcome
to Digital Radio",Press the STANDBY button on the unit (or remote control) to turn the radio on, it will
automatically enter into the DAB+ mode and perform Autotune Quick scan function.
During scan, the display will show "Searching ..." together with a slide bar that indicates the progress of the
scan and the amount of stations that have been found so far.
Once the scan has finished, the radio will select the first alphanumerically found station. To explore the
found stations, Press the SKIP/TUNE SEARCH (UP or DOWN) button to your desired station.
DAB Autotune Full scan modes
Full scan will search for all DAB+Band III channels. After the scan has finished, the first alphanumerically
found station will be automatically selected.
1. To activate autotune full scan, press and hold the PLAY/PAUSE/SCAN button on the unit (or remote
control) to enter into the "Autotune Full scan" mode, the display will show "Searching..." and a slower
progressing slide bar.
2. All the stations that have been found will be stored automatically, to explore the stations that have been
found, the SKIP/TUNE SEARCH ( UP or DOWN) buttonfor selection.
DAB manual tune
1. To select manual tune, press and hold the INFO/MENU button on the unit (or remote control) to enter into
the "Manual tune" mode.
2. Press the SKIP/TUNE SEARCH (UP or DOWN) button to scroll through the DAB+ channels, the display
will show "5A to 13F" and their associated frequencies.
3. W henyour desired frequency appears in the display, press the SELECT/FM MONO/ST. button to
confirm. The name of the station group (ensemble/multiplex) will be displayed.
4. Press the INFO/MENU button to see what stations are present on the found ensemble/multiplex.
FM mode
1. To select FM, press the MODE button on the unit (or remote control), the display will show FM and the
frequency.
2. To activate frequency auto search, press the PLAY/PAUSE/SCAN button once, the frequency band will
scan from down to up; press and hold the PLAY/PAUSE/SCAN button, the frequency band will scan form up
to down; it will stop automatically once a station has been found.
3. You can also press the SKIP/TUNE SEARCH(UP or DOWN) button on the unit (or remote control) to
select your desired frequency.
4. Press the STEREO/MONO button on the unit (or remote control) to toggle select between the FM
"STEREO" and "MONO" reception.
STORING AND RECALLING STORED PRESET STATIONS
In either DAB or FM mode, you can store up to 30 stations to the favourite presets for FM and 30 stations
for DAB; this
will enable you to get direct access to your favourite stations.
ENG-4