Removing And Refitting The Cover - BESAFE iZi Modular A Manual Del Usuario

12
7. When the child is positioned in the seat, place the shoulder belts over
the child's shoulder and collect the two buckle parts together. Then
put the crotch bar upright into the "closed position". In this position,
the belts cannot be pulled out anymore. Click the buckle parts into the
belt buckle. Let the harness retract automatically. (18)
8. Assure that the harness is tight by accessing the shoulder belts inside
the shoulder pads and pulling the shoulder belts upwards. (19)

Removing and refitting the cover

• Do take care when you remove the cover, as refitting the cover is done
in reverse.
• The cover of the head rest can be taken off separately by
disconnecting the beads at the back and pulling off the fabric towards
the front.
! Warning: potential misuse
• The child seat MUST NOT be installed in a front passenger
seat WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that the
floor support is fully pushed down.
• When used in combination with iZi Modular the front brace
must be fitted on the base.
• Make sure the indicators are green before you drive.
Guarantee
• Should this product prove faulty within 24 months of purchase due
to materials or manufacturing fault, except covers and harness
straps, please return it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately
and with care. Please contact your retailer, they will decide if the
seat will be returned to the manufacturer for repair. Replacement
or return cannot be claimed. The guarantee is not extended
through repair.
• The guarantee expires: when there is no receipt, when defects are
caused by incorrect and improper use, when defects are caused
by abuse, misuse or negligence.