Setting The System - Dometic MagicWatch MWE-DCD Instrucciones De Montaje Y De Uso

MagicWatch Accessory
8

Setting the system

See fig. 8 to fig. 9
A
NOTICE!
Incorrect settings can impair safe operation.
When the display is connected, only configure the MWE900 parking aid
using the display buttons.
The display has the following control and display elements (fig. 8):
No. Designation
1 Parameter display
2 Status display
3 Warning LED
4 Displayrange
5 Right button
6 Left button
7 Distancedisplay
8 Audible signal
status
EN
Factory settings activated
F5:
Your own settings
C5:
ON: Display and audible signals are activated
OFF: Display and audible signals are deactivated
Lights up: Obstacle in the stop zone
Flashes: Sensor fault
Red: Obstacle in zone 3 or stop zone
Yellow: Obstacle in zone 2
Green: Obstacle in zone 1
Deactivate display and audible signals until you press this
button again
Programming parameters
Deactivate audible signals until the reverse gear is engaged
again
Programming parameters
Displays the distance in metres to the obstacle in the
detectionrange
Lights up: Audible signals are deactivated
Setting the system
7