Using The Device; Cleaning And Maintenance - Dometic NDS SS12-100 Instrucciones De Uso

Item in wiring diagram
3
4
5
6
7
8
1. Connect the device according to the wiring diagram.
NOTICE! Damage hazard
• Use cables with a section of at least 16 mm² and protect the house battery and also the starting
battery with a 80 A fuse. This may be increased in case of special needs.
• The maximum current of appliances or chargers that can be connected to pin.2 is 100 A. Higher
load thresholds (such as inverters or energy-hungry appliances) may damage the device.
Note The wiring diagram shows an example
• Not all these electrical devices have to be connected for the device to work.
• See operating manual for each electrical device for correct wiring of that specific product.
2. The LED indicator blinks to show that the loads are connected to the battery. If the LED indicator does not blink
after wiring, press the on/off button for 1 second to activate the battery connection.

7 Using the device

If the battery has been disconnected because of low voltage, connect a charging source to the battery to con-
nect it again. As soon as enough state of charge has been reached in the battery, the LED indicator flashes and is
then turned on. The battery connects and supplies the loads with power.
Charging of the house battery can also be done by running the engine to let the alternator charge the battery.
To manually disconnect the battery, press the ON/OFF button. The LED indicator flashes and is then turned off.
The battery disconnects from supplying the loads with power.
To manually connect the battery, press the ON/OFF button. The LED indicator flashes and is then turned on. The
battery connects and supplies the loads with power. The battery voltage must be over 10.5 V for this action to
work.

8 Cleaning and maintenance

The device is maintenance-free.
Occasionally clean the product with a damp cloth.
Description
Starting battery
House battery
Battery charger
Inverter
Power output, electrical appliances
Fuse, 80 A
EN
5