Care & Cleaning; Washing Instructions - Panasonic CS-UE9JKE Manual De Operación

Ocultar thumbs Ver también para CS-UE9JKE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
CARE & CLEANING
CARE & CLEANING
• Switch off the power supply and unplug before cleaning.
• Do not touch the aluminium fin, sharp part may cause injury.
CAUTION

WASHING INSTRUCTIONS

• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
ALUMINIUM FIN
AIR FILTERS
• Clean the filters regularly.
• Wash/rinse the filters gently
with water to avoid damage to
the filter surface.
• Dry the filters thoroughly under
the shade, away from fire or
direct sunlight.
• Replace any damaged filter.
NOTE :
• Take illustrations of CS-UE12JKE for example. Care & Cleaning method for CS-UE9JKE is identical.
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and air
outlet vents:
Cooling: ≥ 8°C
FOR EXTENDED NON-USE
• Activate heat mode for 2~3 hours to thoroughly dry the unit.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
6
Remove
Heating: ≥ 14°C
HINTS
• Clean the filter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
NOTE :
• If chemical cloth is used to wipe the unit, instruction for
the cloth should be followed.
INDOOR UNIT
Wipe the unit gently with
a soft, dry cloth.
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG then CALL
Authorized Distributor under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• The timer indicator blinks and the unit can not be operated.
FRONT PANEL
Remove Front Panel
• Raise and pull to
remove the front panel.
• Wash gently and dry.
Close Front Panel
• Press down both ends
of the front panel to
close it securely.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cu-ue9jkeCs-ue12jkeCu-ue12jke

Tabla de contenido