CARE & CLEANING
CARE & CLEANING
• Switch off the power supply and unplug before cleaning.
• Do not touch the aluminium fi n, sharp part may cause injury.
CAUTION
WASHING INSTRUCTIONS
WASHING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
SUPER ALLERU-BUSTER FILTER
SUPER ALLERU-BUSTER FILTER
Vacuum
• It is recommended to clean this fi lter every 6 months.
• Replace the fi lter every 10 years or replace any
damaged fi lter.
ALUMINIUM FIN
ALUMINIUM FIN
AIR FILTERS
AIR FILTERS
• It is recommended to clean air
fi lters once every 2 weeks.
• Wash/rinse the fi lters gently with
water to avoid damage to the
fi lter surface.
• Dry the fi lters thoroughly under
the shade, away from fi re or
direct sunlight.
• Replace any damaged fi lter.
FOR SEASONAL INSPECTION AFTER EXTENDED
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling/Heating
operation, after 15 minutes of operation, it is normal to have
the following temperature difference between air inlet and air
outlet vents:
Cooling: ≥ 8°C
FOR EXTENDED NON-USE
FOR EXTENDED NON-USE
• Activate heat mode for 2~3 hours to thoroughly dry the unit.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
6
F566761_EN1.indd
F566761_EN1.indd
章节2:6
章节2:6
All manuals and user guides at all-guides.com
Remove
Remove
Heating: ≥ 14°C
HINTS
HINTS
• Clean the fi lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
NOTE:
NOTE:
• If chemical cloth is used to wipe the unit, instruction for
the cloth should be followed.
Remove Front Panel
• Raise and pull to
• Wash gently and dry.
Close Front Panel
• Press down both ends
INDOOR UNIT
INDOOR UNIT
Wipe the unit gently with
a soft, dry cloth.
NON SERVICEABLE CRITERIAS
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG then CALL
Authorized Distributor under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• The timer indicator blinks and the unit can not be operated.
FRONT PANEL
FRONT PANEL
remove the front panel.
of the front panel to
close it securely.
2008-12-10
2008-12-10
8:47:39
8:47:39