Hitachi PC-ALH Manual De Instrucciones página 12

INSTALLATION OF WIRELESS RECEIVER KIT
12
5. Install the wireless receiver kit onto the wall or ceiling as
follows:
A. In Case of Exposing Cable
 Fix the fixing bracket of kit by using screw (A)
at 4 locations
 Cut one of the knockout holes (*) at the cover.
 Lead the cable through the groove and draw
out the cable from the knockout hole.
 Attach the cover. Do not clamp the cable when
attaching the cover.
PMML0174A_r0_11-07.indb 12
B. In Case of Concealed Cable
Screw (A)

Hooking part
Cover

Click sound
Fixing bracket
 Prepare the following box. (Field-Supplied)
JIS Box (JIS C 8336-1991)
a. Switch Box for 1 Controller
(without cover)
b. Small Switch Box for 1
Controller (without cover)
c. Switch Box for 1 Controller
(with cover)
− Rigid Metal Conduit (More than Ø20)
− Screw (M4) (Field-Supplied)
 Insert the cable into the rigid metal conduit.
Cable
 Fix the fixing bracket of kit by using screw
(Field-Supplied).
This figure shows the case of Switch Box for 1
Controller.
Cable
 Attach the cover same as A.
Screws
(field-supplied)
22/11/2007 12:49:41