Kohler K-T11838 Guia De Instalacion página 3

Faucet Outlet Port
Sensor Cover
Setscrew
Apply plumbers putty.
1. Install the Spout
IMPORTANT! Use care when installing the spout to avoid
scratching the finish.
Remove the thread protector and save the three screws. They will
be required to attach the spout shank.
Discard the thread protector.
Thread the spout shank into the faucet outlet port.
Tighten the screws.
Apply plumbers putty or other sealant to the back surface of the
spout escutcheon according to the putty manufacturer's
instructions.
Slide the escutcheon and spout over the spout shank.
Press the escutcheon and spout firmly against the wall.
Remove any excess putty or sealant.
Install the Sensor Cover
Turn the setscrew (already installed in the sensor)
counterclockwise until it is tight. Do not overtighten.
Kohler Co.
Flange
Spout Shank
Screws
Escutcheon
Setscrew
3
Spout
1085970-2-A