Dip Switch Settings Overview; Function Setting - HTW ECO-THERMAL PLUS -V18WD2RN8PLUS Manual De Usuario E Instalacion

3.The automatic setting curve for heating mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
T1SETH1
T1SETH2
State:In the setting the wired controller, if T4H2<T4H1, then exchange their value; if T1SETH1<T1SETH2, then exchange
their value.
4.The environment temperature curves of the low temperature setting for cooling mode
T4
1-T1S
2-T1S
3-T1S
4-T1S
5-T1S
6-T1S
7-T1S
8-T1S
5.The environment temperature curves of the high temperature setting for cooling mode
T4
1-T1S
2-T1S
3-T1S
4-T1S
5-T1S
6-T1S
7-T1S
8-T1S
6.The automatic setting curve for cooling mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
T1SETC1
T1SETC2
State:In the setting the wired controller, if T4C2<T4C1,then exchange their value; if T1SETC1<T1SETC2, then exchange
their value.

10.2 DIP switch settings overview

10.2.1 Function setting

DIP switch is located on the hydraulic module main control board (see "9.3.1 main control board of hydraulic module") and
allows configuration of additional heating source thermistor installation, the second inner backup heater installation, etc.
T1S (T1S2)
T4H1
T4H2
-10≤T4＜15 15≤T4＜22
16
17
18
19
20
21
22
23
-10≤T4＜15 15≤T4＜22
20
21
22
23
24
24
25
25
T1S (T1S2)
T4C1
T4C2
T4
22≤T4＜30
11 8
12 9
13 10
14 11
15 12
16 13
17 14
18 15
22≤T4＜30
18 17
19 18
20 19
21 19
21 20
22 20
22 21
23 21
T4
42
30≤T4
5
6
7
8
9
10
11
12
30≤T4
16
17
17
18
18
19
19
20