Remote Control Compliance - Kohler C3-430 K-27142-CR-0 Manual Del Usuario

Troubleshooting (cont.)
Cleansing Features
Symptoms Probable Causes
C. The Ground-Fault
D. The user is not
2. The seat is A. The mounting
loose.
3. Water stops A. Washing
flowing from
the spray
wand before
cleansing is
complete.
B. The user shifted

Remote Control Compliance

FCC ID: N82-KOHLER030, N82-KOHLER031
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
1354689-5-A
Recommended Action
C. Reset the GFCI or
Circuit-Interrupter RCD.
(GFCI) or Residual
Current Device
(RCD) is tripped.
D1. Small children may
detected by the be too light to be
seat sensor. detected by the
sensor.
D2. Shift your position
on the seat. The
sensor is located on
the front of the seat.
A. Tighten the fasteners.
plate fasteners are Refer to the
loose. Installation Guide.
A. Press the "Front" or
"Rear" icon to restart
automatically stops
1 minute after cleansing.
pressing a spray
icon.
B. Shift your position
position and is no on the seat. The
longer detected by sensor is located on
the seat sensor. the front of the seat.
14 Kohler Co.