Charging Battery; Torque Setting - Meister I-DRILL MAS 12ib Traducción De Las Instrucciones De Servicio Originales

5450480-Akku-Schra-man.qxd
7 – Charging battery
This MeisterCraft MAS 12ib
battery-powered screwdriver
may only be charged using the
CHP090027 mains adapter unit. The
mains adapter unit may only be
operated with a power supply that
has an alternating current of 230 V
and a frequency of 50 Hz. The use of
any other mains adapter units or the
use of the CHP090027 with another
type of power supply may lead to
personal and property damage.
Lithium-ion battery technology
This new type of battery has decisive
advantages over conventional Ni-Cd
batteries:
• No memory effect, i.e. regardless of
its charge status the battery can be
recharged at any time before or after
use without loss of capacity.
• Extremely low self-discharge, so it is
ready for use even after longer storage
periods.
• Light in weight
• Long service life
Charging process (Fig. 2)
Caution! The rechargeable
battery is not fully charged on
leaving the factory. Charge the
rechargeable battery before first use.
Caution! The working temperature
of the charger is 0 degree to
45 degrees.
68
03.08.2010 12:19 Uhr
charging unit with power supply first,
then insert the battery into the
charging unit (6).
1 Connect the charging unit with power,
2 Insert the rechargeable battery into
3 The charging process will last approx.
charging process via an electrical
time-switch clock!
porcess for more than 30 minutes,
please pull out the battery and cool
down for 15 minutes. Then insert it
into charger again, if the LED still
flashes, please send the battery and
charger to the service centre.
8 – Torque setting
The drill screwdriver has a 17-stage torque
setting (2) in order to avoid damage to the
bolt or drilling heads. By rotating the head
on your drill screwdriver, you can adjust
the stage necessary in each case, from
1 (easily turned screw) to max.
Seite 68
Caution! When charge the
battery (5), please connect the
the green LED of the charge control
(7) will light to display mains contact.
the charging unit (6). The red LED will
light and the same time the green one
will be off.
30 minutes and be displayed by red
permanent lighting of the LED. It will
be ended when the red LED goes out
and the green LED lights up.
TIP! It is recommended
additionally to control the
Caution! If the red or green LED
keeps flashing during charging