Torque Specifications; Pre-Operation System Check - Warn 91810 Manual Del Usuario

12. INSTALLATION
(2) U-bolt
(4) 5/16 - 18 Locking Hex Nut
Figure 12: Loosely fasten rear contact plate to rear u-bolts with locking nuts.
Please use the recommended torque specifications when assembling this product unless otherwise specified.
FASTENER SIZE FASTENER TORQUE
lb-ft (N.m)
5/16" U-bolt 17 (23)
3/8" Carriage Bolt 30 (40)
Perform system check:
1. Verify mount orientation is correct (see final assembly image on page 3 for reference).
2. Check fasteners and make sure they are tight and to proper torque.
3. Verify that plow blade can rotate freely without interfering with tires or vehicle body. If interference is found, it may be necessary
to adjust the location of the plow mount towards the front of the vehicle.
4. Verify maximum plow lift height to avoid damage to plow mount, push tubes and frame.
Once system check has been performed, you are ready to operate your plow system.
©2013 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
T O R Q U E S P E C I F I C A T I O N S
Socket /Wrench Size
1/2" socket
9/16" socket
P R E - O P E R A T I O N S Y S T E M C H E C K
13. INSTALLATION
(4) U-bolt
(8) 5/16 - 18 Locking Hex Nut
(6) 3/8 - 16 x 3/4- Carriage Head Bolt
(6) 3/8 - 16 Locking Hex Nut
Figure 13: Tighten all hardware to torque specifications in chart below.
7 91853A1