Operation; Start And Stop; Starting A Cut - Chicago Pneumatic 4123 Instrucciones De Seguridad Y De Funcionamiento

Safety and Operating instructions
Standard retainer, oval collar chisels,
hexagonal shank
A
1. Slide the chisel shank into the oval retainer
hole.
2. Insert the chisel shank into the tool bushing.
3. Rotate and lock the retainer on to the chisel.
4. Slide the retainer on to the cylinder.
5. Lock the retainer by inserting the lock coil
(A).
Standard retainer, oval collar chisels,
round shank
A
1. Slide the chisel shank into the oval retainer
hole.
2. Insert the chisel shank into the tool bushing.
3. Rotate and lock the chisel into the retainer.
4. Slide the retainer on to the cylinder.
5. Lock the retainer by inserting the lock coil
(A).
14

Operation

Start and stop

Start the machine by squeezing the trigger

while firmly holding the handle.
Stop the machine by releasing the trigger. The

trigger will then return to its original position.

Starting a cut

Stand steady and make sure that your feet and

hands are at a safe distance from the inserted
tool.
Press the machine against the surface of the

workpiece before starting.
Adjust the breaking distance (A) so that the

inserted tool does not get stuck.
Do not try to cut too big a bite.

Trying to loosen an inserted tool that is stuck

will expose the operator to unnecessary
vibrations.
CP 4123, CP 4125
9800 0606 90