Abicor Binzel TCS Compact Manual De Instrucciones página 62

6 Putting into operation
6.3.2 Wire cutter
Cutting position
1 2
7 5
1
Stick-out (SO)—free wire end
2 Welding torch
3 Optimal cutting position
Fig. 16 Wire cutter
1 Drive the welding torch (2) into the cutting position.
NOTICE
• Note the desired stick-out length.
• Ensure that the wire is correctly positioned for cutting without touching the cutter fixture (4).
2 Approach the fixed cutting plate (8) (lower cutting edge) with the free wire end.
EN - 24
6
3
9
4
4
Cutter fixture
5 Guiding plate for wire rests
6 Movable cutting plate
Wire cutter open
3
Wire cutter closed
6
7
Grease cup
8 Fixed cutting plate
9 Mounting plate
BAL.0617.0 • 2021-05-20
TCS Compact
8 5