Technical Specifications - Bestway Hydro-Force Treck X2 SET Manual Del Usuario

Technical Specifications

Item 61064 / 61083
2.28m x 1.21m
Inflated Size
(7'6" x 48")
Maximum Weight 170 kg (374 pounds)
Passenger Capacity 2 adults
0.03 bar
Inflation Pressure
(0.5 psi)
Construction of the boat
Inflatable Floor
Inflatable Seat Cushion
(Only for 61068, 61110)
Heavy Duty Handle
Grab Rope Rope Grommet
NOTE: Drawings for illustration purpose only. Not to scale.
Inflatable seats are not included with the following boat size: 1.94m x 1.1m (76'' x 43''); 2.28m x 1.21m (90'' x 48'').
WARNING
Follow all the Safety and Operating Instructions. If you don't follow this instructions, it may cause overturn, explode the
boat and causes to drowning.
1. Do not exceed the maximum recommended number of persons. Regardless of the number of persons on board,
the total weight of persons and equipment must never exceed the maximum recommended load. Always use the
seats / seating spaces provided.
2. When loading the craft, never exceed the maximum recommended load: Always load the craft carefully and
distribute loads appropriately to maintain design trim (approximately level). Avoid placing heavy weights high up.
NOTE: The maximum recommended load includes the weight of all persons onboard, all provisions and personal
effects, any equipment not included in the light craft mass, cargo (if any) and all consumable liquids (water, fuel,
etc.).
3. When using the boat, life saving devices such as life jackets and buoys should be pre-inspected and used at all
times.
4. Before every use, carefully inspect all boat components including air-chambers, grab ropes, oars, and air valves, to
ensure everything is in good condition and tightly secured. Please stop to repair if you find any damage.
5. Buckets, water scoops and air pumps should always be available in case of air leakage or if the boat takes on
water.
6. Passenger numbers and load weights shall by no means exceed specified capacities. Refer to the Technical
Specifications section of this manual to determine passenger numbers and load weights for your boat. Overweight
will cause overturn and drowning.
7. Inflate according the numbered air chamber and rated pressure on the boat, or it will cause overinflation and boat
explosion. Exceeding the data given on the capacity plate may cause the craft to damage, overturn and lead to
drowning.
8. Keep the boat balanced. Uneven distribution of persons or load in the boat may cause overturn the boat and
drowning.
9. When the boat is in motion, all passengers must remain seated at all times to avoid going overboard.
10. Use the boat in protected shore-zones, up to 300m (984 feet). Be careful with natural factors such as wind,
tidewaters and tidal waves. BE AWARE OF OFFSHORE WINDS AND CURRENTS.
11. Be careful when landing on the shore. Sharp and rough objects such as rocks, cement, shells, glass, etc. may
puncture the boat.
12. If one chamber is punctured when the boat is in the water, it may be necessary to fully inflate the other air chamber
to prevent the boat from sinking.
13. To avoid damage do not drag the boat on rough surfaces.
14. Don't leave the boat exposed to sun for long periods of time, as high temperatures shall give rise to air expansion,
which can cause irreparable damage.
15. Always wear a lifejacket!
16. It is the responsibility of the owner/operator to have at least on bucket/bailer on board, secured against accidental
loss.
17. Never transport the boat in inflated condition on the car. Be aware of the potential harmful effects of liquids such as
battery acid, oil, petrol. The liquids may damage your boat.
18. Be responsible, do not neglect the safety rules, this could jeopardize your life and the lives of others.
19. Follow these instructions to avoid drowning, paralysis or other serious injuries.
20. Know how to operate a boat. Check in your local area for information and/or training as needed. Inform yourself
about local regulations and dangers related to boating and/or other water activities.
Inflation
61068
2.55m x 1.27m 3.07m x 1.26m
(8'4" x 50") (10'1" x 50")
225 kg (495 pounds) 270 kg (594 pounds)
2 adults + 1 child 3 adults + 1 child
0.03 bar
(0.5 psi)
Valve
Pressure-scale
Oarlock
Oar Clasp
Oar
(Only for
61068,61110,61083)
61068,61110,61083)
Assembling of the boat
• Spread the boat on a level and even ground.
61110
• Inflate the air chambers with a fitting-boat-pump.
• Never use compressed air!
• Inflate only as far that after inflating one can see some folding at the welding-seams. After inflation compare the
height of the printed scale on the product with the attached scale to make sure reach the height shown in the right list.
Inflate bottom chamber and other accessories such as seat until it is stiff to the touch but NOT hard. DO NOT OVER
0.03 bar
(0.5 psi)
INFLATE.
• Take care that the boat has got the correct pressure. Pay attention to the both pressure scales on the type-plate and
on the inside of the boat. Check after inflating of the boat with the enclosed scale, if the both printed scales on the
boat are identically with the enclosed scale. As soon as both scales are identically, the boat is inflated in a correct
way. If they are not identically, regulate the air by inflating or deflating. After you have inflated all air-chambers, check
the pressure of all air chambers finally once again due to safety reason, because while inflating the other air
chambers, the pressure of the first could change again. Check the pressure from time to time, because in the sun the
pressure can grow and it must be balanced then to correct one. Use the enclosed rope and slip it through the
available grommets. Then make a strong knot (as shown on the enclosed drawing).
Note: Extended exposure to sun can shorten the lifespan of your boat. We suggest not leaving boats in direct sunlight
for more than 1 hour after use.
Item Product Inflated Size
61064; 61083 2.28m x 1.21m (7'6'' x 48'')
61068 2.55m x 1.27m (8'4'' x 50'')
61110 3.07m x 1.26m (10'1'' x 50'')
Foot Pump
(Only for
How to install safety rope:
Please put safety rope through rope grommets and all round holes on tow handle in turn,
to make safety rope surround each side of inflatable boat, then fasten safety rope.
Caution:
1. Safety rope must go through rope grommets and all round holes of tow handle in a
correct way.
2. Please carefully check whether safety rope is in perfect condition and fastened tightly
prior to each use.
Repairs
1. If there is a leak, spray water onto the boat surface and look for air bubbles. Soapy water works well.
2. Clean and dry the damaged area. Apply a repair patch and smooth out any air bubbles.
3. If there are bigger defects at the boat, give the boat to a special repair-shop. Changes in the technical progress are
reserved.
Storage
1. Remove the Oars from the oarlocks.
Note: Keep all accessories for future use.
2. Carefully clean the boat using a mild soap with clean water.
Note: Do not use acetone, acid, and/or alkaline solutions.
3. Use a cloth to gently dry all surfaces. Do not dry the product in direct sunlight.
Note: Also, never dry with equipment such as electric blowers. Doing so will cause damage and shorten the boat's
life span.
4. To deflate, open the valves pushing the control stem in and rotating until the valves stay open. Deflate all the
hull chambers at the same time so the air-pressure drops together. This will prevent damage from occurring to the
boat inner structures.
5. Next deflate the floor.
6. Fold the boat from front to back to remove additional air. You can also use a pump to drain any remaining air.
7. Store in a cool, dry place and out of children's reach.
Deflation
Registration ( For US/Canada customers only )
If you need to register your boat, please have the boat Hull Identification Number and model name ready and then
visit www.bestwaycorp.com/support to obtain your Certificate of Origin, or you can send e-mail to
service@bestwaycorp.us for the Certificate of Origin.
PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE NEW OWNER WHEN YOU
SELL THE CRAFT.
3
Inflated Size
Deflated Size
Chamber 2
10cm
5.4cm
10cm
5.4cm
10cm
5.4cm
Inflatable Seat Cushion
(Only for 61068,61110)
Inflated Size
Chamber 3
11.1cm
11.1cm
11.3cm