Bestway Pavillo Beach Ground 2 Manual Del Usuario página 3

Owner's Manual
Model No.68105
Beach Ground 2 Tent
INTRODUCTION
Proper Use
Any use other than that described or any modification
of the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product
is not intended for commercial use.
Description of parts and features
Tent
1PC
Peg
4PCS
Tent Dimensions ：
Tent: 200cm x 120cm x 95cm
Pitching dimension: 210cm x 130cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your
tent upwind from a camp fire. This will reduce the
chances of having embers land on your tent. In case of
fire, please find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
Poles contain fiber glass. We strongly recommend
wearing gloves during assembly to avoid irritating
hands.
SAVE THESE INSTRUCTIONS
A
Pole
2PCS
Bestway
C
Manual
1PC
ASSEMBLY
Setting up the tent
A
B
1. Lay the tent<A> on the ground. Pull the four corners
outwards.
Note: Make sure that the channels for the poles<B>
are facing upwards.
2. Push the poles<B> completely into the channels.
(FIG1)
3. Stand the tent<A> up and push the ends of the
D
poles<B> into the iron bars (which are on the each
corner of the tent<A>. (FIG2)
4. Fasten the roof of the tent<A> onto the pole
junction with the sewn-on tie. (FIG2)
5. Secure the tent by pushing the tent pegs<C> into
the ground loops. (FIG3)
DISASSEMBLE AND MAINTENANCE
Follow steps 1-5 in reverse order.
1. Clean the tent and remove any stains with sponge
and cool water. Please use non-detergent soap for
serious cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discolouration.
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect
broken frame parts. Use tapes to repair the coating
broken parts.
5. Silicone spray could be use onto zippers if stick.
STORAGE
Store the tent in the stuff sack and place it in a cool, dry
area out of sunlight and away from heat sources and
rodents.
3
B
FIG1
FIG3
B
A
FIG2