Setting Clock; Basic Operation - SOUNDMASTER SCD5800 Manual Del Usuario

CONTENT OF DELIVERY
➢ Main unit
➢ Instruction manual
➢ Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is
easy to operate the machine.
➢ Ensure that the device is sufficiently ventilated.
POWER SUPPLY
➢ Ensure that the voltage is the same as that indicated on the model identification plate.
➢ Connect the power cable supplied to a properly installed safety power socket and the mains
connector AC on the back of the machine.
➢ If you do not use the device for a long time, we recommend disconnecting the device from
the mains.
INSERTING THE BATTERIES
1. Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that the polarity is correct (see
the floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
When the power cord is plugged in, the batteries will not work.
ERP power management
The unit will turn off automatically after 10 minutes in standby mode if there is no audio
signal. To turn on the unit again press the "STANDBY / FUNCTION" button.
The system must be in standby mode in order to set the clock.
1. Press and hold the "PLAY / PAUSE / CLOCK" button for approx.2 seconds.
2. Use the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons to set the time format "12 / 24hr".
3. Press the "PLAY / PAUSE / CLOCK" button to confirm time format.
4. Use the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons to set the hours accordingly. The
hour digits start flashing.
5. Press the "PLAY / PAUSE / CLOCK" button to confirm the hour.
6. Repeat step 4 and 5 to set the minute.
NOTE: If the voltage is interrupted, the time is lost
SWITCH DEVICE ON/OFF
➢ Press the "STANDBY / FUNCTION" button to turn on the device.
➢ Press the "STANDBY / FUNCTION" button for approx. 3 seconds to switch into the standby
mode.
ADJUSTING VOLUME
Press the "VOLUME –" or "VOLUME +" button to decrease or increase the volume.
INSTALLATION
➢
Microphone
➢
AC power cable

SETTING CLOCK

BASIC OPERATION

2
SCD5800 / English Instruction Manual