RoboCam ZC15 E Guia Del Usuario página 4

3. Installation of the Xcam 2 on its Pan'n Tilt base
1 Pan'n Tilt Base
1 mounting bracket
1 power supply 12 V / 200mA
1. Remove the lid over the base, by pulling
down the clip marked «front».
3. Pass the jack plug of the camera into the
notch
4. Neatly coil the camera into the spindle,
insert the spindle center over the plastic
stick under the lid
5. Insert the power jack of the camera into
the one of the base. Put the two jacks
into the lid.
2. Position the camera with its cable at the
front of the lid (where the notch for the
cable is), and attach the camera using the
screw provided.
6. Close the lid again, putting the 2 «front»
marks face to face
7. Screw the Pan'n Tilt base on the mounting
bracket (optional)
Page 3