RoboCam ZC15 E Guia Del Usuario página 7

To clear all stored positions:
Move the switch at the bottom to program. Press Center then move the switch back to normal.
With the switch set to normal:
Press P1, P2, P3 or P4 to move to any of the 4 positions stored for the camera.
Press center to center the position for the camera.
Press Sweep to sweep through all 4 positions stored for the camera.
To stop scanning or movement to a stored position:
Press any Blue key on the remote while the camera is moving to stop the movement.
To turn the camera off:
Unplug its power supply. For multiple camera systems a Transceiver is required, which then lets
you turn the cameras on and off by remote control.
5. Multi Camera Operation
The Remote lets you turn on up to 4 Pan 'n Tilt cameras or scan each of them in turn (forward or
back ward) so as to display the image from each camera in turn on your TV.
You have to purchase a Transceiver (TM12 or TM13), which will have the same House code as the
Power Supply of all the cameras, for example "A".
Connect each camera (up to 4) to its own Pan and Tilt base, plug each one into its addressable
Power Supply, and set each to a different unit code between1-4, 5-8, 9-12 or 13-16. To control 4
different cameras, press the button for the camera you want to control (C1, C2, C3 or C4) then
press the other buttons as described for single camera operation. For example :
1. Press C1 to select the first camera
2. Move the switch at the bottom from Normal to Program
3. To store the first position for the camera controlled by C1, press the Blue buttons to scan to the
position you want. Press P1.
4. To store thesecond position for the camera controlled by C1, press the Blue buttons to scan to
the position you want. Press P2.
5. To store the third position for the camera controlled by C1, press the Blue buttons to scan to the
position you want. Press P3.
6. To store the fourth position for the camera controlled by C1, press the Blue buttons to scan to the
position you want. Press P4
7. Move the switch back to Normal.
Press C2 and repeat steps 2 to 7 above to store 4 positions for Camera C2.
Press C3 and repeat steps 2 to 7 above to store 4 positions for Camera C3.
Press C4 and repeat steps 2 to 7 above to store 4 positions for Camera C4.
To clear all stored positions:
Move the switch at the bottom to program. Press Center then move the switch back to normal.
Page 6