Uline H-2763 Manual Del Usuario

π
H-2763, H-2764
STACKABLE DRUM RACKS
TOOLS NEEDED
3/4" Wrench (2)
NOTE: The H-2763 and H-2764 are intended for
use with the most currently available 55 gallon
steel drums. Minimum recommended drum
wall thickness for the bottom layer of drums on
a 3 high stack is 20 gauge. On a 4 high stack
it is 18 gauge. Use of drums with walls that are
too thin may not be safe. If you are not sure of
the specifications of your drums, check with
your supplier(s). Make sure all drums are in
good condition.
WARNING! To reduce the risk of accident
or injury: Be sure to stack racks only on
fully loaded racks. Never stack onto a rack
containing only one drum.
NOTE: Assemble all parts loosely.
1. Place washer on bolt.
2. Insert bolt through hole in saddle weldment, then
through hole in tube weldment. Put nut on end of
bolt. Be sure flat washer is on outer side of saddle
weldment.
PAGE 1 OF 3
1-800-295-5510
uline.com
SAFETY INFORMATION
• The H-2763 and H-2764 are not to be used with
plastic drums.
• Only move racks singly or stacked 2 high. Stacks
3 high or 4 high should not be moved under any
conditions.
• When using fork trucks to move loaded racks, make
sure forks are set at maximum usable width to insure
stability.
• It is strongly recommended to stack racks one at
a time.
• Check all bolts periodically to insure tightness.
Inspect unit periodically for any damage that may
have occurred from use or exposure to corrosive
materials.
ASSEMBLY
3. Assemble unit together in this manner loosely using
all bolts.
4. Tighten all bolts. Do not overtighten.
Para Español, vea página 2.
Pour le français, consulter les page 3.
IMPORTANT! Read all instructions
before using these drum storage
racks.
0521 IH-2763