Cleaning And Maintenance; Spare Parts; Disposal Information - Renfert MT3 Guia De Inicio Rapido

Operation
Trimming
EN
⇒ If necessary check and adjust the grinding angle.
⇒ Turn on appliance.
After switching on, wait until the trimmer disc has reached the rated speed (approx 2 - 3 seconds).
Start trimming only then.
⇒ Adjust water flow rate at water inlet (14).
⇒ Using both hands, securely set the model on the grinding table and press it against the disc.
Once the work has been finished:
⇒ Switch off the appliance.
The water supply shutoff tap should be closed when work is interupted for longer periods and
when the appliance is unattended (e.g. over

Cleaning and Maintenance

The device does not include parts which require maintenance.
It is not permitted to open the device!
⇒ Switch off and unplug the appliance before cleaning or servicing.
⇒ Close water supply shutoff tap.
Do not steam clean the housing!
⇒ Only wipe with a damp cloth.
⇒ Open door latches (6), remove door and set aside.
⇒ Clean door with a brush or cleaning cloth under running water.
⇒ Wipe the internal space with a brush or cleaning cloth.
⇒ Pull grinding table (5) at leading edge upward from ball head.
⇒ Clean grinding table with a brush under running water.
⇒ Turn rinse tube (18) backwards at curved side and take out.
⇒ Allow the rinse tube to soak in decalcifying agent overnight.

Spare Parts

You can find components subject to wear and the spare parts on the spare part list in the internet at
www.renfert.com
The components excluded from the warranty (such as consumables or parts subject to wear and tear)
are marked on the spare part list.

Disposal Information

Within the European Union, units with this symbol should not therefore be disposed of in
unsorted domestic waste.
Please contact your local authorities for more information on proper disposal.
night).
- 4 -
Subject to change