Mellerware Bari Legend Manual Del Usuario página 10

Anomaly
- Water flows out of the
side of the holder
- No coffee comes out
- The coffee comes out
slowly or drop by drop
- The coffee comes
without cream
- The coffee comes out
too fast
- No steam escapes
from the evaporator
tube
Possible cause
- The filterholder is not fitted
correctly.
- The Edge of the sieve is
covered with coffee.
- The brewing group is dirty.
- There is no water
The water tank is not proper-
ly placed.
- The filter holes are clogged,
the coffee is ground too fine
or has been pressed too
much
- The coffee grinding is too
fine or too pressed
- The used Coffee is out of
date
- The Coffee has not been
pressed enough.
- The Ground coffee is too
coarse.
- The ground coffee is too
coarse.
- There is not enough coffee in
the sieve.
- The Coffee has not been
pressed enough
- The Tube is clogged
Solutions
- See Section "filling coffee"
- Clean the sieve around the edge and
clean the brewing of coffee group
- Clean With a damp cloth.
- Fill the water tank
- Make sure the tank is properly
seated, pressing the tank forward
and ensure the tank is locked by the
water tank buckle
- Empty the filter basket and clean
with water. Clean the brewing unit
with a damp cloth. Fill the sieve
again and press the coffee slightly
- Make sure grinding is OK and it's not
too pressed.
- Use Fresh coffee and once opened
store in an airtight container.
- Press slightly the coffee.
- Grind finer the coffee
- Grind coffee finer
- Ensure that it's the right amount of
coffee in the sieve.
Press slightly the coffee
- Clean the steam tube with a damp
cloth to remove any traces of milk
have dried and unblock holes using
a needle. Press the corresponding
switch and remove steam until it
goes out continuously