Bestway Pavillo Hike Dome 2 Manual Del Usuario página 3

Owner's Manual
Model No.#68096
HIKEDOME 2 TENT
INTRODUCTION
Proper Use
Any use other than that described or any modification
of the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product
is not intended for commercial use.
Description of parts and features
A1
Outer Tent Inner Tent
1 PC 1 PC
C
Guy rope Peg
1 PC 13 PCS
Tent Dimensions：
Inner tent: 220cm x 160cm x 90cm
Outer tent: 250cm x 230cm x 95cm
Pitching dimension: 260cm x 240cm
W2
W1
L1
L2
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your
tent upwind from a camp fire. This will reduce the
chances of having embers land on your tent. In case of
fire, please find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
SAVE THESE INSTRUCTIONS
Choose a suitable site
Removing any sharp objects, which might damage the
groundsheet.
A2 B
Pole
1 PC
D E
Carry Bag
1 PC
H
ASSEMBLY
Setting up the tent
A2
FIG1
45°
WARNING: Poles contain fiber glass. We strongly
recommend wearing gloves during assembly to avoid
irritating hands.
1. Lay the outer tent <A2> on the ground, pull the four
corners outwards
Note: make sure that channels for the poles<B> are
face upwards
Note: make sure that the zip on the entrance to the
tent is closed
2. Push the poles<B> completely into the
channels(FIG1)
3. Stand the inner tent<A2> up and push the ends of
the poles<B> into the holder bar of inner tent<A2>
4. Secure inner tent<A2> by inserting tent
pegs<D>(FIG2)
5. Fasten the outer tent<A1> onto the pole junction
with sewn-on ties
6. Put the outer tent<A1> on inner tent<A2> (FIG3)
7. Tie one end of the guy ropes<C> onto front corner
hoop of outer tent<A1> .(FIG3)
8. Tie the other end onto the tent pegs<D> and fasten
them by inserting the tent pegs<D> into
ground(FIG3)
9. Note: Ensure that guy ropes<C> are about at an
angle of 45°.
10.Do not pull the guy ropes<C> too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-10 in reverse order.
1. Clean the tent and remove any stains with sponge and
cool water. Please use non-detergent soap for serious
cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discolouration
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect broken
frame parts. Use tapes to repair the coating broken
parts.
5. Silicone spray could be use onto zippers if stick
STORAGE
Store the tent in the stuff sack and place it in a cool, dry
area out of sunlight and away from heat sources and
rodents.
3
D
FIG2
FIG3