Sanus Systems VM200 Manual Del Usuario página 3

Thank you for choosing a Sanus Systems VisionMount™ wall mount. The VM200 is designed to mount up to 40" LCD TVs weighing less than 80 lbs
to a vertical wall. It will allow you to effortlessly tilt the TV ±20°.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor
or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective parts. Our customer service
representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through
authorized dealers will be shipped directly to you. Never use defective parts. Improper installation may cause damage or serious injury. Do not use this
product for any purpose that is not explicitly specified by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect
mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of purchase.
Note: The supplied wall mounting hardware is not for metal stud or old cinder block walls. If you are uncertain about the nature of your wall, consult
an installation contractor. Sanus makes every effort to assure all necessary television mounting hardware is included. If the hardware you need is not
included please consult your local hardware store or call Sanus Systems.
Required Tools: Drill, 3/16" drill bit, (1/2" masonry bit for brick, concrete, or concrete block installations), socket set and a Phillips screw driver
Supplied Parts and Hardware: Some parts not shown as actual size*
(1) Wall Plate - a*
(3) Lag Bolt - d
TV Mounting Hardware:
(4) M4 x 10 mm Bolt - g
(4) M4 x 30 mm Bolt - j
(4) M4 Lock Washer - m
(4) M4/M5 Washer - p
Assembly Instructions for Model: VM200
(1) Left Monitor Bracket - b*
(3) Lag Bolt Washer - e
(4) M5 x 12 mm Bolt - h
(4) M5 x 30 mm Bolt - k
(4) M5 Lock Washer - n
(4) M6 Washer - q
(1) Right Monitor Bracket - c*
(4) M6 x 12 mm Bolt - i
(4) M6 x 35 mm Bolt - l
(4) M6 Lock Washer - o
(4) M4/M5 Spacer - r
(3) Concrete Anchor - f
(4) M6 Spacer - s