Overmax X-bee 9.5 Manual De Usuario página 40

How to disassemble the camera
1.
EN
2.
How to adjust the camera angle
You can adjust the camera angle by 90° with the use of the knob (see: fig. 4).
Turn the knob „up" (marked as A in the fig. 4) to lift the camera. Analogically,
turn it „down" (marked as B in the fig. 4) to lower the camera.
Note: Before the drone lands, make sure the camera is positioned
downwards (fig. 13).
How to assemble a battery in the
remote control
Open the battery cover, insert two AA batteries in the compartment in
accordance with the pole marking and, next, close the cover (see fig. 14).
How to connect the remote control to
the dron
Press and hold the lock key (6)
the on/off key (see: fig. 15).
You can connect the remote control to the drone only if the controller is
not connected to any other drone. If there are a few different kinds of
drone and controller in one place, pairing must be performed one after
another to avoid wrong pairing.
Grab the camera and turn it left by 90° (fig. 12).
Gently pull and remove the camera from the port. Remove the camera
plug.
and activate the controller by sliding