Overmax X-bee 9.5 Manual De Usuario página 45

control loses connection to the drone for more than 6 seconds. You can
regain control over the drone if the remote control regains connection and
you press the return key.
NOTE:
•
During emergency return, you cannot control the drone to avoid
obstacles.
•
The drone will not return to the starting point if the GPS signal is poor
(below 7 satellites).
•
During smart return, if the user wants to move the drone higher than
15 m, the drone will stop ascending and initiate the emergency return
procedure.
•
If there is not a good GPS signal during the take-off (below 7 satellites),
and the drone loses connection to the remote control for more than
6 seconds, the drone will start descending and lock after landing.
3. Low-battery return
This mode activates when the drone battery is so low than it may influence
its ability to return to the spot marked as „home".
When rear LEDs of the drone flash slowly, the battery indicator shows
low battery status (
drone is at the height of more than 30 meters or distance of more than 100
meters from the remote control, the drone will return to the starting point
automatically.
When rear LEDs of the drone flash slowly, the battery indicator shows it is
flat ( ), the remote control emits short sounds, while the drone is at the
height of more than 15 meters or at a distance of more than 15 meters from
the remote control, the drone will return to the starting point automatically.
Due to flat battery, it is not possible to regain control when you press the
return function during return.
Due to low battery, if the distance is 100 meters or less, you can cancel the
return by pressing the return key during return.
), the remote control emits short sounds, while the
EN