Lanaform Stim Fit Manual De Instrucciones página 4

Screen :
EN
1. Indicates of length of treatment
2. Modes:
a) Kneading
b) Acupuncture
c) Tapping
d) Friction
e) Application of suction pads (pumping)
f) Combination of 5 modes
3. Intensity display (10 levels)
4. Battery charging status
Use :
1) Preparation prior to use
The Stim Fit is battery-operated. Before using your device, check that it is charged. The battery charge indicator must
be full (diagram 2, point 4).
You should also check that your skin is clean and dry.
Before switching on your device, place the electrodes where you want them to be on your body (see paragraph below).
Fix the cables to the electrodes, then connect them to the stimulator..
2) Diagram showing position of electrodes
When using the Stim Fit and when you apply the elec-
trodes, the use of two electrodes for each group of muscles
is recommended. For assistance, see diagram below.
We do not recommend using two electrodes on opposite
sides of the body (for example: the electrode of the first
cable on your left arm and the electrode of the second
cable on your right arm).
For optimum, safe use, we recommend dividing and connecting the electrodes as shown on the diagram below.
Please note: Never apply the electrodes to the head. Never move the electrodes when the device is running. Put the
device on pause, then simply remove the electrodes and put them in a different place, otherwise, some impact might
be felt.
4
DIAGRAM 2
1
2f
2e
3
DIAGRAM 4
2
2a
2b
2c
2d
DIAGRAM 3