Lanaform Mirror X7 Manual De Instrucciones página 4

Thank you for your interest in the LANAFORM ® X7 Mirror. This X7 magnifying wall mirror with LED lighting will find a
EN
special place in your home.
PLEASE READ ALL THE INSTRUCTIONS BEFORE USING YOUR X7 MIRROR, ESPECIALLY
THIS BASIC SAFETY INFORMATION:
• Only use this device according to the instructions given in this manual.
• Ensure that the voltage indicated on your appliance is the same as that of your mains voltage.
• This device is not intended for use by people (including children) with reduced physical, sensory or mental capabilities,
or persons with lack of experience or knowledge, unless a person responsible for their safety can supervise or instruct
them beforehand on how to use the device. Children should be supervised to ensure that they do not play with the
appliance.
• Do not use accessories that are not recommended by LANAFORM® or that are not supplied with this device.
• If the power cable is damaged, it must be replaced by a special lead or assembly available from the manufacturer or its
service agent.
• Do not use this device if the power plug is damaged, if the device is not working properly, has been dropped on the floor
or if it is damaged or has been dropped into water. Have the device examined and repaired by the supplier or its after-
sales department.
• Never let anything drop or insert any object into any openings.
• Do not carry this device by its power cable or use the cable as a handle.
• To disconnect the device, turn off the light, then remove the plug from the mains.
• Always disconnect the device after using it and before cleaning it.
• Unplug a device that has fallen into water immediately before retrieving it.
• An electrical device must never remain plugged in without supervision. Disconnect it when you are not using it.
• Keep the power cable away from hot surfaces.
• Never use this device in a room where aerosol products (sprays) are used or in a room or where oxygen is being
administered.
• Never attempt to plug in or unplug this device if you are in contact with water. This may cause a risk of electric shock.
• Never immerse the device in water or any other liquid to clean it.
FEATURES
• Rotating mirror
• 2 pivoting arms
• Mains-operated
• Fittings supplied
• Chrome colour
INSTRUCTIONS FOR USE
In order to install the mirror refer to the steps at the beginning of these instructions.
1. Unscrew the 2 screw heads from the base.
2. Remove the plate from the base and drill 4 holes in the wall.
3. Fix the plate to the wall.
4. Fix the base to the plate and tighten the 2 screw heads.
5. Your mirror has been installed. Insert the supply cable into the hole designed for this purpose.
4