Connection Panel (Lun 15A - Lun 12A Lun 10A) - My Audio LUNARIS Serie Manual De Instrucciones

■
1 x LUN15 SA + 2 x LUN12 A
■ 2 x
LUN15 SA + 2 x LUN12 A
■
1 x LUN12 SA + 2 x LUN10 A
■ 2 x
LUN12 SA + 2 x LUN10 A
6. CONNECTION PANEL...................................................Fig. 3
LUN15A - LUN12A - LUN10A - LUN18SA - LUN15SA - LUN12SA
1. INPUT COMBO CONNECTOR
This connector according to the LINE/MIC selector position, you can connect line or microphone signals. For the connection
use BALANCED signal cables with XLR or JACK connectors.
2. XLR-M LINK CONNECTOR
Producing the same signal that is connected to the INPUT COMBO (LINK): it can be use to daisy-chain several speakers
together.
3. LINE/MIC SELECTOR
Use this button to select the input sensitivity of the built-in amplifier. In the LINE position (button up) the input accepts
line signals from equipment with high-level outputs. In the MIC position (button down) the input accepts the signal coming
from a dynamic microphone connected directly to the speaker without the need of an external mixer.
4. VOLUME
Level control of the signal sent to the built-in amplifiers. The nominal sensitivity is different according to the LINE/MIC
selector's position (LINE +4dB / MIC -40dB).
5. PRESET SELECTOR
The 4 PRESETS available in all models have been prepared in order to provide the loudspeaker systems with different
acoustical responses suitable for different applications, different kind of signal and different tastes. It enables to select
the 4 PRESETS of equalization that are available only with LUNARIS 15A - LUNARIS 12A - LUNARIS 10A.
▻ FLAT: this PRESET has been prepared to provide the best frequency response for the reproduction of recorded music
and is suitable for DJs, installations in public venues and multimedia applications.
▻ STAGE: this PRESET provides a flat response, suitable for LIVE setups and for any applications requiring the 'natural'
response of the loudspeaker system.
▻ MONITOR: this is the PRESET to be chosen when the LUNARIS Active
response has been adjusted in order to compensate the reflections from the floor, while the mid-high EQ provides a clear
and intelligible sound.
▻ VOICE: this PRESET can be used when you connect a dynamic microphone directly to the speaker's input. The equalization
contained in this PRESET allows to get from the microphone a brilliant and intelligible response even without using a mixer.
6. PEAK LED
It indicates when the CLIP LIMITER starts operating following the detection of a too high signal level being fed to the
amplifiers
In this case, the LIMITER lowers the signal level to avoid damage to the enclosure components and amplifier clipping.
www.myaudio.it
- LUNARIS ACTIVE SERIES -
are used as stage monitors. The frequency
LUNARIS ACTIVE