Installation And Connections - My Audio LUNARIS Serie Manual De Instrucciones

■
LUNARIS 10A: it is fitted with a 1" compression driver horn and with a 10" woofer. The built-in power module includes
one 200W RMS AB amplifier for the low section and one 50W RMS AB class amplifier for the high section.
■
LUNARIS 18SA: it is a sub-woofer system fitted with a 18" woofer, with a power handling of 500W RMS.
■
LUNARIS 15SA: it is a sub-woofer system fitted with a 15"woofer, with a power handling of 400W RMS.
■
LUNARIS 12SA: it is a sub-woofer system fitted with a 18" woofer, with a power handling of 350W RMS.
■
LUNARIS 15MA: it is a stage monitor fitted with a 15" coaxial loudspeaker. The 1" compression driver is in the center of
the woofer. The built-in power module includes one 300W RMS AB amplifier for the low section and one 50W RMS AB class
amplifier for the high section.
■
LUNARIS 12MA: it is a stage monitor fitted with a 12" coaxial loudspeaker. The 1" compression driver is in the center of
the woofer. The built-in power module includes one 250W RMS AB amplifier for the low section and one 50W RMS AB class
amplifier for the high section.
■
LUNARIS 10MA: it is a stage monitor fitted with a 10" coaxial loudspeaker. The 1" compression driver is in the center of
the woofer. The built-in power module includes one 200W RMS AB amplifier for the low section and one 50W RMS AB class
amplifier for the high section.
■
LUNARIS 8MA: it is a stage monitor fitted with a 8" coaxial loudspeaker. The 1" compression driver is in the center of
the woofer. The built-in power module includes one 180W RMS AB amplifier for the low section and one 30W RMS AB class
amplifier for the high section.
The models with bi-amp power amplifiers are fitted with high-precision active crossover and independent limiters for the
high and the low section. Finally, the three Sub-woofer systems are equipped with fixed frequency
filter.

5. INSTALLATION AND CONNECTIONS

1. INSTALLATION
All the LUNARIS Active series models are fitted with an adapter for the installation on a standard loudspeaker stand. The
three Sub-woofer systems have an adapter on the top panel for the installation of a satellite using a telescopic pole.
Thanks to the shape of their cabinet, the models of LUNARIS Active series can be placed on the floor in horizontal
position and used as stage monitor.
2. CONNECTIONS (FIG.2)
The inputs of the LUNARIS Active loudspeaker systems can be used with line signals coming from devices with high-level
outputs. For the connection, use BALANCED signal cables with XLR or JACK connector.
signal can be set using the VOL control. If you are using devices with a too high output level, you can reduce the input
gain turning the control counter clock wise.
If you need to send the same signal to a second loudspeaker system you can use the XLR-M LINK connector.
3. SUB + SATELLITE SYSTEMS
In the following configurations you can find the suggested Sub-woofer + satellite setups for the LUNARIS Active
speakers.
■
1 x LUN18 SA + 2 x LUN15 A
■ 2 x
LUN18 SA + 2 x LUN15 A
www.myaudio.it
- LUNARIS ACTIVE SERIES -
by an active crossover
The input level of the incoming
LUNARIS ACTIVE