Troubleshooting - Zeegma Draden Manual Del Usuario

Troubleshooting

EN
No steam
To little steam
Water comes out of
nozzle instead of steam
Too long heating up
The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective
collection. The product must not be disposed of along with domestic waste
as it may pose a threat to the environment and human health. The worn-out
product must be handed over to the electrics and electronics recycling center.
The pictures are for reference only. The real design of the products may differ from the
pictures presented.
Problem Possible cause
No power supply
No water in the tank
Too low voltage or
unstable voltage
Too little water in the
tank
Too much water in
the tank
Exceeded inclination
of the product when
using
Voltage is too low or
unstable
Solution
Check if the socket works
and if equipment has been
connected properly
Refill water in accordance with
the guidelines in the manual
(see chapter: how to use the
product)
Check if the socket works
and if equipment has been
connected properly
Refill water in accordance with
the guidelines in the manual
(see chapter: How to use the
product)
Pour out some water from the
tank. The suggested amount is
250 ml
When the device operates,
the body of the machine must
not be inclined at the angle
exceeding 45 degrees. Do
not incline the equipment too
much during its operation
Check if the socket works and
if equipment has been connec-
ted properly