VGE XCLEAR AOP COMPACT OZONE + UV-C Manual Del Usuario página 4

XCLEAR AOP COMPAC T OZONE + UV-C
EN
OPERATION
Ozone has been used for decades for disinfecting drinking water and for purifying air. This
substance has very strong oxidation and sterilisation properties on all organic substances and takes
away unpleasant odours. This makes it one of the most effective means of sterilisation for water
treatment. UV-C radiation and ozone together form the perfect combination for making (pond)
water immaculately clean and rich in oxygen. Ozone and UV-C kill algae, viruses and bacteria. The
use of ozone is a natural process which is artificially imitated by the AOP Compact Ozone + UV-C.
This equipment consists of an air pump, a UV-C / ozone combination lamp and a static mixer. The air
pump carries air past the combination lamp which produces about 0.6 grams of ozone. The loaded
air is mixed with water in the static mixer where an oxidation process takes place. Once disinfection
has taken place then the water mixed with ozone is carried past the combination lamp again but
this time there is a quartz glass housing as a partition.
EARTHING INSTALLATION (DRAWING 2)
1. Pull the cable (2) through the strain relief (4) before fitting the synthetic strain relief (4) onto the
earth bolt (1). Position the strain relief (4) at approximately 10 cm from the eye (2) of the earth
cable.
2. Place the eye (2) of the cable onto the earth bolt that is fitted to the housing.
3. Then place a toothed lock washer (3).
4. Fit the strain relief (4), creating a loop of Ø5 cm.
5. Finally place the second toothed lock washer (5) and the lock nut (6) onto the earth bolt.
6. Once the parts have been placed onto the earth bolt in the correct sequence, they can be
tightened with a spanner or a ring spanner number 8.
INSTALLATION (DRAWING 3 & 4)
Never submerge this equipment in water. Always install in a dry and well-ventilated area. Determine
the desired input and output side of the device. Standard delivery is with the input on the right
side. If you wish to change this then undo the unit including the pre-switching device (A) from the
plate and remove the plate for the air pump (B). Turn the plate round and refasten all the parts again
in the opposite direction. Take the air pump out of the packaging and turn the supplied double
plug (C) in the air pump (the supplied parts in the bag are not used in the ozone application). Put
the air pump on the plate and connect the 2 air hoses to the pump; one air hose goes to the UV-C
device (D) and the other leads to the static mixer (E). To disconnect the air hose, press the blue ring
in and pull out the air hose (Drawing 4). Fasten the device vertically with a space of at least 30cm
being available on the underside for any maintenance. There must be about 1.5m space at the top
so that the lamp (F) can be replaced without problems without having to undo the whole unit
4 | XCLEAR AOP COMPACT OZONE + UV-C
IMPORTANT
Before installing this equipment please read these instructions carefully. Take care: this
equipment contains glass, handle with care! During maintenance or repairs always
disconnect the plug from the socket!