Battery And Charger; Technical Data - Degometal GO 248 Manual De Instrucciones

2.3.3 The red warning Light is lit
Problems and causes
Jaw assembly does not return to start position
Overload (warning light is on)
Overheated
Discharged battery
NOTE: If the solutions provided above have no effect, the tool must be repaired by qualified
personnel or returned to the dealer or manufacturer's representative; see page 9.

3. Battery and charger

3.1 Technical data

Battery
Nominal voltage:
Cell:
Number of cells:
Capacity:
Weight:
3.2 Battery charging and safety instructions
3.2.1 Charging
Only charge batteries supplied by authorized dealers.
The Li-ion battery is protected against deep discharge by the 'Electronic Cell Protection' (ECP).
When the battery is discharged, the tool is switched off by a protection circuit.
Connect the charger to the correct power supply; the green LED will light up to indicate that there is
power to the charger. Slide the battery onto the charger.
- During the charging process the red LED is lit continuously.
- As soon as the battery is charged, the red LED switches off and the green LED lights up.
If the battery is very hot (>45 °C) or in some way defective, the green LED will light up immediately
when the battery is pushed onto the charger and the charging process will not begin.
www.degometal.com
18.0VDC
Li-ion
5 or 10
1.5Ah / 3.0Ah
0.38 kg / 0.69 kg
Solution
Release the trigger
Check whether the blind rivet is suitable for the
tool. Remove the battery once to reset
Remove the battery and allow the tool to cool in
the open air
Recharge the battery or replace if necessary
Charger
Input voltage: 100-240VAC / 50-60Hz
Output voltage: 18.0VDC
Output current: 1.5A max.
Weight: 0.37 kg
- 7 -