Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing washer
in position on the basin.
3.
Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4.
Connect the supply pipes to the isolation
valves; cold right - hot left.
5.
31612000/31613000/31622000
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:0,1 – 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
6
7l /min 0,3 MPa
12l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
65° C
If the continuous water heater causes any
problems or there is not enough flow of water, the
EcoSmart® (5a) located behind the aerator must
be removed.
To adjust the hot water limiter on single lever
mixers, please see page 8.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts (see page 2)
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 aerator
6 pull rod
7 fixing set
8 connection hose 3/8"
9 connection hose Ø 10
Special accessories
X special tool set 58085000
(order as an extra)
31692000
96338000
97406000
97209000
92730000
13912000
96657000
96016000
97206000
96321000
Publicidad
