Mopar 82212323 Manual De Instrucciones página 2

2
1. Disconnect the battery negative cable.
2. Remove the right side instrument panel end cap.
3. Remove the right side instrument panel silencer push
in fasteners.
4. Disconnect the LED harness (1) and remove the right
side instrument panel silencer (2).
5. Open the glove box door (3).
6. Remove the two side screws (2) from the glove box
compartment (1).
7. Remove the six screws from the front of the glove box
compartment (1).
8. Using trim stick C­4755 or equivalent, pry out on the
glove compartment (1) to disengage the retainer clips
from the Instrument Panel (I/P).
9. Disconnect the wiring harness connector and junction
block from the back of the glove box compartment (1)
and remove from the vehicle.
10. Place the headlamp switch (1) rotary knob (4) in the
OFF (O) position.
11. Push in on the rotary knob (4) and rotate clockwise to
retract the retainers (2) behind the I/P trim. The retain­
ers (2) will be fully retracted before the switch points
to the park lamps ON position.
12. Pull the switch out of I/P trim to access and discon­
nect the headlamp switch connector, and remove the
headlamp switch.
13. Connect the headlamp switch connector to the new
headlamp switch.
14. Position the new switch and press firmly and evenly
into the I/P trim until it is fully seated. Two light audi­
ble clicks will indicate that the two retainers (2) have
seated.
Nov 24, 2010 K6861133