Mopar 82212323 Manual De Instrucciones página 7

33. Route the LH side of the fog lamp harness (2) along
the front of the lower radiator support (3) and connect
to the LH fog lamp.
34. Attach the harness (2) using tie straps (1) as neces­
sary.
35. Under the hood in the engine compartment, and from
in front of the ABS module (3), route the connector
and ground wire (2) with the eyelet under the ABS
module (3) and connect the fog lamp harness (4) to
the fog lamp/BCM harness.
36. Remove the body ground nut (1), attach the ground
wire (2) eyelet to the stud and install the nut (1).
37. Route the fog lamp harness (4) and fog lamp/BCM
harness (4) with the engine harness and attach with
tie straps (5) as necessary.
38. Connect the wiring harness connector and junction
block to the back of the glove box compartment (1).
39. Position the glove compartment (1) and firmly push
into place to seat the push in fasteners.
40. Install the two side screws (2) to the glove box com­
partment (1).
41. Install the six screws to the front of the glove box com­
partment (1).
42. Install the silencer.
43. Connect the battery negative (2) cable.
44. Configure the vehicle as follows:
a. Log on to https://dealerconnect.chrysler.com.
Nov 24, 2010
7
K6861133