Motorola noise-com ENMN4010 Manual De Instrucciones página 3

Ensure the noise-com flanges, Fig. 1 (2), fit
behind the solid washer which is located
behind the soft cushions inside the ear
protector cup. Do not use excessive force!
3. Turn the noise-com
o
90 clockwise in the
cup as shown.
4. Pull the cups
outward and position
the combined
noise-com and ear
protectors over your
ears so that the ear
cushions fully enclose the ears and seal tightly
against your head.
5. Bend the microphone boom gently towards
your mouth. To obtain maximum sound quality
and ambient noise cancellation the
microphone must be kept close to the lips at a
distance of 10-15mm.
Note: If you want to change the side of the
ear protector on which the noise-com is
attached (e.g. from left to right), twist the
microphone boom gently 180
above (1) and the microphone end 45
shown above (2). Return to Step 1 of the
Installation section to complete the
installation of the noise-com into the ear
protectors.
˚
180
o
as shown
2
o
as