Advanced Mode - Beninca BE.PROXY Manual De Instrucciones

3 Hold the card to be memorised near the BE.PROXY reader, which responds with the OK
message.
To store other cards in memory, repeat from point 2.
At end of programming, move DIP1/2 back to OFF.
To erase a card code
1 Press the PGM button twice. The green LED L2 flashes with a frequency of 2 flashes
followed by an interval.
2 Hold the card to be erased from memory near the BE.PROXY reader, which responds with
the OK message.
To erase other cards, repeat from point 2.
Complete erase of memory
Press the PGM button and keep it pressed for 15s. The red LED L3 and the green LED L2, which
are initially switched off, start flashing in an alternate way. When they stop flashing, the erase
operation is completed.
WARNING: If the advanced mode is not used, the J4 jack must be opened by means of a
welder (Fig. 2) in order to protect the receiver from the creation of MASTER cards.
Creation of the MASTER card.
1 Move DIP3 to ON.
2 Move the card destined to be the MASTER card, to the BE.PROXY reader, which responds
with the OK message.
3 Move DIP3 back to OFF.
It is recommended to clearly mark the MASTER card and keep it in a safe place for any future
need.
It is not possible to create more than one MASTER card, and any further attempt in this sense
will cause an ERROR message. To create a new MASTER card, memory should be completely
erased (see BASIC mode) thus erasing also the previous MASTER card.
To memorise a card code on channel 1
1 Hold the MASTER card near the reader,
you should hear one 3s beep from the buzzer and the LED should be lit with solid light,
followed by 1 beep/second with corresponding flashing of the LED.
2 Hold the card to be memorised near the BE.PROXY reader, which responds with the OK
message. The buzzer then returns to the wait mode and 1 beep/second is emitted with
corresponding flashing of the LED.
3 For the following cards to be to be stored in memory, proceed as described at point 2.
5 At end of operation, hold the MASTER card near the reader, you should hear 2 beeps of
3sec from the buzzer with corresponding flashing of the LED.
To memorise a card code on channel 2
1 Hold the MASTER card near the reader,
you should hear one 3s beep from the buzzer and the LED should be lit with solid light,
followed by 1 beep/second with corresponding flashing of the LED.
2 Hold the MASTER card near the reader again,
you should hear 2 beeps/second from the buzzer, with corresponding flashing of the LED.
3 Hold the card to be memorised near the BE.PROXY reader, which responds with the OK
message. The buzzer then returns to the wait mode and 2 beeps/second are emitted with
corresponding flashing of the LED.
4 For the following cards to be stored in memory, proceed as described at point 3.
5 At end of operation, hold the MASTER card near the reader, you should hear 2 beeps of
3sec from the buzzer with corresponding flashing of the LED.
10

ADVANCED MODE