Beninca BE.PROXY Manual De Instrucciones página 11

To memorise a card code on channels 1 and 2
1 Hold the MASTER card near the reader,
you should hear one 3s beep from the buzzer and the LED should be lit with solid light,
followed by 1 beep/second with corresponding flashing of the LED.
2 Hold the MASTER card near the reader again,
you should hear 2 beeps/second from the buzzer with corresponding flashing of the LED.
3 Hold the MASTER card near the reader again,
you should hear 3 beeps/second from the buzzer with corresponding flashing of the LED.
4 Hold the card to be memorised to the BE.PROXY reader, which responds with the OK
message. The buzzer then returns to the wait mode and 3 beeps/second are emitted with
corresponding flashing of the LED.
5 For all the following cards to be stored in memory, proceed as described at point 4.
6 At end of operation, hold the MASTER card near the reader, you can hear two 3s beeps
from the buzzer, with corresponding flashing of the LED.
To erase one card code
1 Hold the MASTER card near the reader,
you should hear one 3s beep from the buzzer and the LED should be lit with solid light,
followed by 1 beep/second with corresponding flashing of the LED.
2 Hold the MASTER card near the reader again,
you should hear 2 beeps/second from the buzzer, with corresponding flashing of the LED.
3 Hold the MASTER card near the reader again,
you should hear 3 beeps/second from the buzzer, with corresponding flashing of the LED.
4 Hold the MASTER card near the reader again,
you should hear 4 beeps/second from the buzzer, with corresponding flashing of the LED.
5 Hold the card to be memorised near the BE.PROXY reader, which responds with the OK
message. The buzzer then returns to the wait mode and 4 beeps/second are emitted with
corresponding flashing of the LED.
6 For the following cards to be erased, proceed as described at point 5.
7 At end of operation, hold the MASTER card near the reader, you can hear two 3s beeps
from the buzzer, with corresponding flashing of the LED.
To disable the Buzzer
1 Move DIP1 and DIP2 to ON.
2 Hold the MASTER card near the reader,
the LED lights up. The buzzer is disabled.
3 Move DIP1 and DIP2 back to OFF.
To enable the Buzzer
1 Move DIP1 and DIP2 to ON.
2 Hold the MASTER card near the reader,
you can hear 2 beeps from the buzzer, with corresponding flashing of the LED. The buzzer
is enabled.
3 Move DIP1 and DIP2 back to OFF.
Cards memorised on one single channel cause the immediate switch as they are placed near
the BE.PROXY reader.
As regards cards memorised on both channels, proceed as follows:
If channel 1 is to be activated, approach the card to the reader once.
If channel 2 is to be activated, quickly approach the card to the reader two times (within 2s).
HOW TO USE THE CARDS
11