VOLUME
Enables adjustment of the volume.
Touch the keys
Press "OK" to confirm.
MOV.
Enables the user to enable the move-
ment sensor: if the touchscreen has not been turned
off via the ON/OFF key, this turns on automatically at
the time it is moved.
Select the required item. Press "OK" to confirm.
FIRMW.
Enables display of the firmware ver-
sion of the touchscreen.
RESET
Enables the user to clear the entire
memory of the touchscreen. Important! – This
function does not delete the parameters stored on
the control unit; see paragraph 5.4 - "Alarm system"
instruction manual programming.
Select the required item. Press "OK" to confirm.
4 - WALL-MOUNTED SUPPORT FIXTURE
Warnings
• Ensure that the wall-mounted support of the touchscreen is
placed on a sufficiently solid surface.
• Never position the support in the vicinity of strong heat
sources.
01. Mark the fixing points on the wall, drill the holes, insert the
plugs supplied and secure by means of the screws sup-
plied (fig. 3);
or
to make the setting.
02. Attach the support and insert the touchscreen (fig. 4).
5 - PRODUCT MAINTENANCE
The touchscreen does not require special maintenance; in any
event, it should be cleaned periodically using a soft cloth damp-
ened with water; never use detergents or solvents.
6 - BATTERY REPLACEMENT
Caution! – Never use new battery models different from
the specified version.
When the symbol
flashes and the red led is lit, this means
that the battery charge is low and should be replaced (or
recharged if rechargeable) as soon as possible. If completely
discharged, replace (or recharge) immediately. When batteries
are partially discharged, the radio range between devices is re-
duced and system operation is not guaranteed. Therefore re-
place the batteries to restore correct operation. Use 2 batteries,
1.5 V type AA.
01. Open the cover (fig. 2): press on point 1 and then push
the base upwards (point 2);
02. Replace the batteries with 2 of the same version, taking
care to observe polarity;
03. Close the cover.
Disposal of batteries
Caution! – The backup batteries and battery packs in the
devices present in this alarm system, also if discharged,
contain pollutant substances and therefore must not be
disposed of as household waste. Dispose of according
EN
English - 9