Mhouse MATS1 Instrucciones Para El Uso página 8

3.2 - Using the touchscreen to control
EN
automations
The touchscreen can be used to control different types of
automation in the Mhouse range (gates, doors, awnings, shut-
ters, lights etc.). Up to 16 commands can be programmed. A
specific name must be given to each one (for example: "open
gate 1") and assign the category (type) of the automation (e.g.
"Gates").
Then perform the following sequence:
1. Create a command on the touchscreen
(paragraph 3.2.1)
2. Memorise a command in the automation receiver
(paragraph 3.2.2)
3.2.1 - Creating a command on the touchscreen
01. Turn on the touchscreen and touch the icon
mands) on the main screen;
02. Scroll through the icons on the right by touching the sym-
bol ;
03. Touch (Set) and then "Commands".
04. In the list displayed, touch "Command 1", followed by
"Name" and write the name of the command (for exam-
ple: "open gate 1"); then press "OK" to confirm.
05. Touch "Type", then select one of the three types of
automation to be controlled as required (for example
"Gates"); then press "OK" to confirm.
06. Press "OK" to confirm.
Repeat the same procedure to create other commands.
6 - English
3.2.2 - Memorising the transmitter in the automation
receiver
After creating the required commands, each of these must be
memorised in the receiver of the automation to be controlled.
Before proceeding, set the receiver for memorising a com-
mand in "Mode II" (for further information see the system
instruction manual and the web site www.mhouse.com). Cau-
tion! - Do not use the procedure for "Mode I".
01. On the main screen, touch the icon
02. Touch the icon of one of the 3 types of automation to
which the automation has been assigned (for example
"Gates");
03. When requested by the automation control unit proce-
dure, press and hold the command created (e.g. "open
gate 1") to send it. Blue led lit = transmission in progress.
(Com-
3.2.3 - Programming the 4 immediate keys (fig. 1)
Each of the 4 immediate keys can be associated with one of
the created commands as required.
01. On the main screen, touch the icon
02. Scroll through the icons on the right by touching the sym-
bol ;
03. Touch (Set) and then "Immediate keys";
04. Touch "Key 1" and on the list of commands displayed,
select the command to be associated (e.g. "open gate 1")
then press "OK" to confirm;
05. Press "OK" to confirm.
Repeat the same procedure to program the other keys.
(Commands);
(Commands);