Publicidad
Idiomas disponibles
Idiomas disponibles
7.
After lifting up the hood, the ready dish can be removed.
8.
As soon as the temperature falls below the set value, the thermostat will automatically
turn on the heating element and the yellow indicator of heating will light up. Thus, the
heating element operates cyclically.
9.
If the thermostat knob is turned to the far right position corresponding to the maximum
temperature, the heating element will be switched on permanently.
10.
The grill is equipped with two thermostats that allows you to switch on both heating
elements at the same time or separately.
11.
When you are done, turn the thermostat knob counterclockwise to the "0" position and
turn off the power (unplug it).
12.
If the power cord is damaged, the equipment must be stopped immediately and service
must be provided for replacement.
7.
Maintenance and care
Before cleaning the equipment, disconnect the power supply (unplug it).
Stainless steel grid and tray can be removed and washed separately with warm soapy
water. It is not allowed to use piercing and cutting objects for cleaning the equipment.
It is necessary to wipe the surface of the equipment and the power cord with a soft
sponge or cloth moistened with warm soapy water in the end of every working day. Washing
of the equipment under a direct water stream or submergence thereof into water is not allowed.
The energized equipment shall not be left unattended. If the equipment is idle for a long
time, it should be disconnected from the mains.
During a long break in the operation of the equipment, it should be thoroughly cleaned
and stored in a well-ventilated area in the absence of corrosive substances.
8.
Troubleshooting
Fault
1. The power
indicator (green)
is off
2. The heating
indicator
(yellow) does
not light up
when the heating
element is
switched on
3. The heating
element does not
work
4. The hood does
not move up or
down.
Possible reason
●
The equipment is not
connected to the mains
●
There is no power
●
The bulb went
●
The bulb went
●
The indicator circuit is
open
●
The heating element is
broken
●
The thermostat is broken
●
There is a foreign object
that prevent the hood
movement
●
Lifting device is broken
Solution
● Check the connection
● Make sure that the power
supply is energized
● Replace the bulb
● Replace the bulb
● Check the connection
● Replace the heating
element
● Replace the thermostat
● Remove the back panel of
the equipment for
troubleshooting
EN
15
Publicidad
