Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
User Manual
•
Remove dead batteries immediately and dispose of per
local codes.
•
Do not dispose of batteries in fire.
•
Keep batteries out of reach of children.
•
Remove batteries when the device is not in use
•
Use only the charger specified for your rechargeable
battery pack.
Personal Safety
•
Stay alert, watch what you are doing and use common
sense when operating a laser tool. Do not use tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating power tools may
result in serious personal injury.
•
Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of
the tool in unexpected situations.
•
Use safety equipment. Always wear eye protection. Dust
mask, non-skid safety shoes, hard hat, or hearing protection
may be required for appropriate conditions.
Tool Use and Care
•
Do not use tool if switch does not turn it on or off. Any tool
that cannot be controlled with the switch is dangerous and
must be repaired.
•
Store idle tools out of reach of children and other untrained
persons. Tools are dangerous in the hands of untrained
users.
•
Use only accessories that are recommended by the
manufacturer for your model. Accessories that may be
suitable for one tool, may become hazardous when used
on another tool.
Service
•
Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by unqualified
personnel could result in a risk of injury.
•
When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock
or injury.
To locate your nearest DeWALT service center go to http://www.
dewalt.com on the Internet.
6
Operating Tips
•
Use only new, high-quality, name brand AA batteries or
specified rechargeable DEWALT 10.8V Li-Ion pack for best
results.
•
Ensure batteries are in good working condition. If the low
battery red indicator light is flashing, the batteries need
replacement.
•
To extend battery life, turn laser off when not working with
the beam.
•
To ensure the accuracy of your work, check to make sure
your laser is calibrated often. See Field Calibration Check.
•
Before attempting to use the laser, make sure it is
positioned securely, on a smooth, flat surface.
•
Always mark the center of the beam created by the laser.
•
Extreme temperature changes may cause movement of
internal parts that can affect accuracy. Check your accuracy
often while working. See Field Calibration Check.
•
If the laser has been dropped, check to make sure your
laser is still calibrated. See Field Calibration Check.
•
Place the laser on a smooth, flat, stable surface that is level
in both directions.
Low Battery Indication
The DCE088R and DCE088G lasers are equipped with
a battery gauge as shown in Figure 5B. The battery gauge
indicates remaining power with each LED representing 25%.
The bottom LED will illuminate and blink indicating that the level
is low (below 12.5%) and the batteries need to be replaced. The
laser may continue to operate for a short time while the batteries
continue to drain, but the beam(s) will quickly dim. After fresh
batteries are installed and the laser is turned on again, the laser
beam(s) will return to full brightness and the battery indicator
level will indicate full capacity. (A flashing laser beam is not
caused by low batteries; see Out of Tilt Range Indicator.) If all
4 LED's on the battery meter LED's continuously flash this does
not indicate a low battery; see "The Battery Meter LED's Flash"
under Troubleshooting.
Operation
To Turn the Lasers On and Off
(See Figure
2
,
5
)
With the laser off, place it on a flat surface. This model has
B
a pendulum locking switch
laser beams with two ON/OFF buttons; one for a horizontal
D
laser line
and one for a vertical laser line
is powered on by moving the pendulum lock switch
C
and a keypad
to activate the
E
. Each laser line
B
to the
Publicidad
Tabla de contenido
