Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
42 09 07R / 31.07.2019
Packing list:
1 8-conductor cable set
1 Connection socket
1 Blinker control module
1 Screws M5X10
1.
Disconnect the earth lead from the battery
Limousine: remove the floor cover plate in the boot space, take the car jack out and dismount the covering of the
2.
luggage compartment. Deflect the rear coverings towards the rear lights.
3.
Variant: deflect the floor covering in the boot space forward and take luggage shelves on both sides out. Deflect the
cover plate of the spare wheel well up and remove the boot sill cover.
4.
In order to lead the cable bundle through, remove the cover plate in the rear metal sheet panel under the left rear
position light.
Connect the cable set in the following way:
5.
a)
Draw 8-connector end of cable set with installed socket through the hole referred to in point four from
boot outside and then through the hole in socket base.Fasten cable bush located on cable bunch in the
holeinside the vehicle.
b)
There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow
hook with folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other
washer assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow
hook without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c)
Socket is connected according to the following scheme:
Picture1
Function:
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
Electrical Set for Trailer Connection
7-pin
VW Passat Sedan manufactured 10.96 - 09.00
VW Passat Variant manufactured 06.97 - 09.00
Part no.:
420907R
WYR
3 Screws M5X35
4 Nuts M5
4 Spring washer
1 Fuse base
Installation instruction
Contact description:
1
(L)
2
(54-G)
3
(31)
4
(R)
5
(58-R)
6
(54)
7
(58-L)
8
(58-b)
1 Fuse 10A
1 Fuse holder
1 3-conductor wire bundle
2 Cable ties 300 mm
Cable colour:
black/white
grey
brown
black/green
grey/red
black/red
grey/black
grey/white
8 Cable ties 100 mm
1 1-conductor wire bundle
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
Publicidad
Tabla de contenido
