Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
04 09 13R-T / 18.03.2019
Packing list: 1 12-conductor cable set
1 13-pin socket
1 Socket retaining plate
1 Trailer indicator modules Trail-tec 12-00
1.
Disconnect the earth lead from the battery.
2.
Remove boot bottom cover and clamping ring for a spare wheel. Remove rear wall casing and both side hatches of
the boot.
3.
To draw cable set through (connection with socket), drill a 6 mm diameter hole below the right rear parking lamp
(near guidance inside the vehicle). Expand the hole to approximately 40 mm diameter. Secure the hole with an anti-
corrosive remedy.
4.
Connect cable set in the following way:
a)
Draw 12-connector end of cable set with installed socket through the hole referred to in point three from
boot outside and then through the hole in socket base. Fasten cable bush located on cable bunch in the
hole inside the vehicle.
b)
There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow
hook with folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other
washer assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow
hook without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c)
Socket is connected according to the following scheme:
Picture1
Function
Contact description
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Assemble connection socket with packing washer using enclosed screws and nuts on socket holder:
a)
Carefully fasten washer in the appropriate way,
b)
Fasten electric bunch in such a way that there are no sharp bends and no wear.
Electrical Set for Trailer Connection
040913R
WYR
Part no.
13-pin
BMW 7 er E 38 manufactured 06.94 -10.01
1 Screws M6X10
3 Screws M5X35
3 Nuts M5
Installation instruction
Cable colour
1
black/white
2
grey
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
2
red/blue 2,5mm
10
2
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
4 Spring washer
1 Fuse base with a fuse
1 Red connection cable
1 Nuts M6
9
10
11
2
Contact description in
13-pin socket
2
3 Cable ties 300 mm
10 Cable ties 100 mm
1 Sheet-metal screw
8
7
1
6
2
4
3
5
12
13
Publicidad
Tabla de contenido
