Simu T5 E Manual Del Usuario página 4

2.6- Adjustment of up end limit:
The use of bottom slat stopper will allows an automatic adjustment of the up end limit in accordance with the blocking
provided by the stopper. If you use it, go directly to step 2.7, otherwise proceed to the following operations:
a- Position the motor on the desired up end limit using the s and t keys.
b- To memorize the up end limit, press t twice, as follow:
- 1st press for 0,5 second without the motor rotation.
- 2nd press over 3 seconds, so the motor rotates briefly one way, then the
other*. Go to step 2.7.
2.7- Validation of end limits:
- Press the s and t keys simultaneously for at least 3 seconds. The motor will run briefly in one
direction and then in the other*. The settings are now complete. There is not delay time any more.
You can now connect the motor to the final switch (§3).
3
Final wiring
- Mandatory use of a reversing switch that stops
the s and t keys being activated simultaneously.
- Possibility of wiring 3 motors maximum in parallel
on one switch.
- Be careful of the direction of rotation (§2.2).
- The cable may only be connected to the motor by qualified personnel.
- The connector is to be assembled without damaging the contacts. - The continuity of the earth connection must be ensured.
4
Re-adjustment of end limits
4.1- Re-adjustment of down end limit:
In case of an automatic adjustment (with rigid link) the re-adjustment will also be automatic (every 56 cycles). In this case, do
not proceed to the following operations.
a b
6s
>>
a- Position the motor on the down end limit set in §2.5 using the t key.
b- Press the t key 3 times, each time for 6 seconds. After the second and third press the motor rotates briefly one way, then
the other*.
c- Position the motor on the new desired lower position using the s and t keys.
d- To confirm the new End Limit position, press s twice, once for 0,5 second without the motor rotating and the second
time for at least 3 seconds, so the motor rotates briefly one way, then the other*.
4.2- Re-adjustment of up end limit:
In case of an automatic adjustment (with buttom slat stopper) the re-adjustment will also be automatic (every 56 cycles). In
this case, do not proceed to the following operations.
a b
6s
>>
a- Position the motor on the up end limit set in §2.6 using the s key.
b- Press the s key 3 times, each time for 6 seconds. After the second and third press the motor rotates briefly one way, then the
other*.
c- Position the motor on the new desired high position using the s and t keys.
d- To confirm the new End Limit position, press t twice, once for 0,5 s without the motor rotation and the second time for at least
3 seconds, so the motor rotates briefly one way and then in the other*.
5
Cancelling the end limits adjustment
- Connect the motor to the settings switch (§2.1)
- Press the s and t keys simultaneously, for at least 7 seconds. The motor rotates one way,
then the other*, then a few seconds later rotates in both directions*. After this operation,
the motor returns to its factory settings; repeat the operations from chapter 2.
2/2
6s
+ >>
6s max. 6s max.
6s
+ >>
6s max. 6s max.
a
Blue
Brown
Black
Green/yellow
c
6s
+ >>
c
6s
+ >>
b
0,5s
>>
>>
PE
L
N
d
0,5s
>>
d
0,5s
>>
>7s
≥3s
+ >>
6s max.
≥3s
>>
>3s
+ >>
6s max.
>3s
+ >>
6s max.
>>
>>
2s
7s