Checking The Rotation Direction - Simu T3.5 Manual Del Usuario

Compatible transmitters
3
1 2
1 : Wall Hz transmitter
2 : 1/5 channels Hz transmitter
- Do not position the transmitter near metal in order to avoid range losses.
End limits adjustment
4
If the installation includes several motors, only one motor is to be powered during this programming pro-
cedure. It will eliminate interferences with the other motor during the procedure.
4.1
- Switch ON the motor.
- Simultaneously press the UP and DOWN keys of a
Hz transmitter. The motor will run for half a second
in one direction, then in the other.
The transmitter now controls the Hz.02 motor
in unstable mode, move to stage 4.2.

4.2 - Checking the rotation direction

Press the UP key of the transmitter:
a- If the motorized tube runs in the UP direction , move to next stage (4.3).
b- If the motorized tube runs in the DOWN direction, reverse the rotation direction by pressing the STOP key
for at least 3 seconds. The motor will confirm the reversal of the rotation direction by running for half a
second in one direction, then in the other direction. Move to the stage 4.3.
a
>>
b
4.3 - Adjustement of the end-limits : memorizing the end points
The end-limit adjustement can be done in two ways:
- First you can memorize the DOWN position (a) and then the UP position (b).
- First you can memorize the UP position (b) and then the DOWN position (a).
a
1
1- Position the motor on the DOWN end limit using the
"DOWN" and "UP" keys.
2- To memorize the DOWN end limit position, press simulta-
neously the "STOP" and "UP" keys. The motor will run
automatically in the "UP" direction.
3- Before the motor reaches the UP end limit, press the
"STOP" key.
3 4
3 : Hz timer
4 : Long-range Hz transmitter
>> OK >> 4.3
>>
3s
2 3
Transmitters range :
- 1, 2 and 3 : 20 m through 2 concrete walls .
- 4 : 40 m m through 2 concrete walls.
Location of the "PROG" key on Hz transmitters :
1 2
PROG
>>
b
1
1- Position the motor on the UP end limit using the "UP"
and "DOWN" keys.
2- To memorize the UP end limit position, press simulta-
neously the "STOP" and "DOWN" keys. The motor will
run automatically in the "DOWN" direction.
3- Before the motor reaches the DOWN end limit,
press the "STOP" key.
3
PROG
>>
ON
>> OK >> 4.3
2
4
3
2 / 4