Fermax 24201 Manual De Instrucciones página 19

4. Jumpers, switchers and LED indicators
The tables below indicates the use of the jumpers (first table), LEDS (sec-
ond table) and SW1 (table on next page).
ON
JUMPER 0
ON
JUMPER 1
I
JUMPER 2
LED
GUARD UNIT status
X
PANIC MODE status
Y
RST RESET system
MAIN POWER status
POWER
DECODER BUS status
RDX
TDX DECODER BUS status
PANEL 0 status
P0
PANEL 1 status
P1
RPX PANEL BUS status
PANEL BUS status
TPX
Activates audio in Panel nº 0
(for testing purposes)
Activates audio in Panel nº 1
(for testing purposes)
CT in camera activated from
Central Unit
MEANING
OFF
OFF
E
ON
ACTIVATED DEACTIVATED
ACTIVATED DEACTIVATED
There is a
problem
System is
System is not
powered
There is a
All Decoders are
blocked
in stanby mode
Decoder
Central Unit
interface is not sending data
blocked
Audio in panel 0
Panel 0 or Guard
or Guard Unit is
Unit is not in use.
in use
Audio in panel 1
in use
There is a All panels are in
blocked panel
Central Unit
All panels are in
interface is
blocked
NORMAL operation
NORMAL operation
CT in camera activated from
monitors.
OFF BLINKING
System is in PC
MODE TEST
All is correct
powered
power supply
Some Decoder
sends data to
Central Unit is
sends data to
to Decoders Decoder BUS
Not possible
Panel 1 is not
Not possible
in use
sends data to
standby mode
sends data to
stanby mode
not possible
There is a
problem
There is a
problem in
Central Unit
Central Unit
Some panel
Central Unit
Central Unit
panel BUS
Pag. 19